Lamps, Lighting

A neon lamp is a gas discharge lamp containing primarily neon gas at low pressure. The term is also used for similar devices filled with other noble gases, usually to produce different colors. more...

Home
Animals
Arcade, Jukeboxes & Pinball
Autographs
Banks, Registers & Vending
Barware
Bottles & Insulators
Breweriana, Beer
Casino
Clocks
Furniture, Appliances & Fans
Housewares & Kitchenware
Knives, Swords & Blades
Lamps, Lighting
Candle Holders
Ceiling Fixtures
Lamp Repair, Refurbishing
Lamps: Electric
Lamps: Non-Electric
Neon
Other Lighting
Sconces
Shades
Linens, Fabric & Textiles
Metalware
Militaria
Pens & Writing Instruments
Pez, Keychains, Promo...

Description

A small electric current, which may be AC or DC, is passed through the tube, causing it to glow orange-red. The exact formulation of the gas is typically the classic Penning mixture, 99.5% neon and 0.5% argon, which has lower striking voltage than pure neon. The applied voltage must initially reach the striking voltage before the lamp can light. Once lit, the voltage required to sustain operation is significantly (~30%) lower. When driven from a DC source, only the negatively charged electrode (cathode) will glow. When driven from an AC source, both electrodes will glow (each during alternate half cycles). Neon lamps operate using a low current glow discharge. Higher power devices, such as mercury-vapor lamps or metal halide lamps use a higher current arc discharge.

Once lit, a neon lamp has a negative resistance characteristic: increasing the current flow through the device increases the number of ions, thereby decreasing the resistance of the lamp and allowing even more current to flow. Because of this characteristic, electrical circuitry external to the neon lamp must provide a means to limit current flow through the circuit or else the current will rapidly increase until the lamp is destroyed. For indicator-sized lamps, a resistor is conventionally used to limit the current flow. Larger neon sign sized lamps often use a specially constructed high voltage transformer to limit the available current, usually by introducing a large amount of leakage inductance in the secondary winding.

When the current through the lamp is lower than the current for the highest-current discharge path, the glow discharge may become unstable and not cover the entire surface of the electrodes. This may be a sign of aging of the indicator bulb, and is exploited in the decorative "flicker flame" neon lamps. However, while too low a current causes flickering, too high a current increases the wear of the electrodes by stimulating sputtering, which coats the internal surface of the lamp with metal and causes it to darken.

The flickering effect is caused by the differences of the ionization potential of the gas, which depends on spacing of the electrodes, temperature, ambient radiation, and the pressure of the gas. The potential needed to strike the discharge is higher than what is needed to sustain the discharge. When there is not enough current to ionize the entire volume of the gas around the electrodes, only partial ionization occurs and the glow forms around only part of the electrode surface. Convective currents make the glowing areas flow upwards, not unlike the discharge in a Jacob's ladder. A photoionization effect can also be observed here, as the electrode area covered with the discharge can be increased by shining light at the lamp.

Read more at Wikipedia.org